logoGemini Archives  The following products have been Discontinued.


  • Taurus II.2
  • Titan

Taurus II.2a



Taurus II.2  Specifications

  • 16 1/2" x 10 1/2" work surface
  • 5 1/2" throat depth 1 1/8" throat height
  • 1/5 horse power motor.





Taurus 2 Accessory Kit

Taurus II.2 Accessory Kit

This kit is equipped with helpful tools for completing any project from cutting straight lines to perfect circles and precise angles. This kit can be purchased from your local stained glass supplier.

Powered by 3 AA batteries (not included). Attaches to the back of your saw with velcro (included). Great for adding light and removing shadow from the work area.

Straight Edge

This tool gives the ability to cut straight lines, which would ordinarily be very difficult with your ring saw. Fits anywhere on the saw's work surface.

Circle Maker

This item works on any location of the work surface and helps to create perfect circles.
Hole Reducer

These fit inside the hole of the work surface to keep small pieces of material from falling into the saw and jamming the rotating assembly which could lead to rapid wear, failure and even blade breakage. Note: These hole reducers only work for the Taurus II models.

30/60 Degree Cutoff Triangle

Works in unison with the straight edge to cut a 30 or 60 degree angle.
45  Degree Cutoff Triangle

Works in unison with the straight edge to cut a 45 degree angle.
Bevel Edge Maker

This works in unison with the straight edge to make perfect 45 degree beveled edges.
Lamp Wedge

Use the lamp wedge to put a 30 degree bevel on the edge of a finished piece. This will allow the pieces to fit together more tightly, allowing for a smaller, stronger solder joint.
Face Shield

This piece attaches to the front of the saw and keeps flying debris and water away from your eyes.
Taurus II.2  Ring Saw Accessory Kit Instructional Video

Titan XT

Hot Glass and Glass Tile Saw

» The Titan cuts straight lines up to 12 inches long every time. It accomplishes this by way of a carriage tray that moves forwards and backwards while it stays perfectly aligned with the rigid ring blade. Makes trimming a cinch.

» The Titan comes with a Megablade that is very fast cutting and leaves an extremely smooth edge.

» Titans can expose a full 3 inches of blade. This makes it perfect for cutting not only pattern bars, glass tile, millifiori, stained glass, glass tubes, rods, streamers, etc. but also cuts bottles, vases and other tall and hollow pieces.

» Fantastic for hard to cut three dimensional blown glass. The Titan can also be used to cut curves both forward and backward in stained glass, wall tile, and glass tile.

» Included with the Titan are triangles for cutting 45/90/30/60 degree angles.

» Titans will fit on any table with a footprint of 12 by 18 inches.

» The Titan is a Wet Table Saw with a Smooth Cutting Blade



 Drive Motor: 1/5 Horsepower 110 Volt, 50-60hz

Also available at extra charge: 220 volt, 50-60hz transformer with european power cord

Weight:  15 pounds

Warranty:  1 year limited